How to Clean Dirty Laces Without a Washing Machine

Grubby laces are usually the first thing people notice on an otherwise clean pair of trainers. The good news is you don't need a washing machine to sort them out — a bit of warm water, the right brush and a little patience will get most laces looking white or bright again, usually within ten minutes of actual work.
Machine washing laces is tempting because it's fast, but it's also how laces fray, lose their aglets (the little plastic tips), or come out of the wash twisted and never sit flat again. Hand cleaning takes a bit longer but gives you full control over how hard you scrub, which matters a lot once you're dealing with suede eyelets, reflective strips or laces that have gone grey rather than just muddy.
This guide covers flat cotton and nylon laces, plus the trickier reflective and waxed types, and goes through what actually causes laces to discolour in the first place so you're not just treating the symptom.
Key takeaways
- Warm water, a mild detergent and a soft-to-medium brush will shift most everyday lace grime without a machine.
- Reflective and waxed laces need a different approach — scrubbing them like cotton laces can strip the coating.
- Grey, dingy laces are often a build-up of fine dirt in the weave rather than one visible stain, so they need a soak, not just a wipe.
- Always unlace fully before cleaning — laces left threaded through eyelets never get properly clean and can transfer dirt back onto the upper.
- If laces are more stained than dirty (ground-in mud, oil, grass), treat the stain before the general wash, not after.
Why laces get dirty faster than the rest of the shoe
Laces sit lower than most of the upper and get dragged through puddles, mud and pavement grit every time you walk. They're also handled constantly — tied, untied, pulled tight — which presses dirt and skin oils into the weave rather than letting it sit on the surface where it would brush off. That's why laces often look worse than the shoe they're attached to, even when the rest of the trainer has had a proper clean.
Cotton and canvas laces are the most absorbent, so they pick up and hold grime fastest. Nylon and polyester laces resist staining a bit better but show scuffing and yellowing from UV exposure. Waxed laces (common on some boots and smart trainers) don't absorb water in the same way, which is exactly why they need their own method below.
The basic hand-wash method for cotton and nylon laces
- Unlace completely. Pull the laces all the way out of the shoe. This protects the eyelets from getting soaked and lets you clean every section of the lace evenly, including the bit that normally sits hidden under the tongue.
- Pre-treat any visible stains. Dab a small amount of stain remover or a paste of baking soda and water directly onto mud or grass marks and leave it for five minutes before you start the general wash. Skipping this step is the most common reason a stain is still visible after the rest of the lace comes up clean.
- Mix warm water with a mild detergent. Washing-up liquid or a small amount of laundry detergent in a bowl of warm (not hot) water works well. Hot water can set certain stains and, on coloured laces, encourage dye bleed.
- Submerge and agitate. Drop the laces in and work them gently with your fingers for a minute or two so the water gets into the weave, then leave them to soak for 15–20 minutes.
- Scrub along the length. Use a soft-to-medium bristle brush (an old toothbrush is fine for most laces) and scrub in short strokes along the lace rather than across it, which is gentler on the weave and less likely to fray the edges.
- Rinse thoroughly. Run the laces under clean water until no more suds or discolouration comes off. Leftover detergent is a common reason laces look dull once dry.
- Reshape and air-dry flat. Lay the laces out straight on a towel, away from direct heat or sunlight, and leave them for several hours. Drying flat stops them drying into a curl, which is harder to fix once set.
A worked example: muddy festival laces
Say you've come back from a muddy festival weekend with laces that are stiff, brown at the bottom third, and starting to smell. Start by letting them dry out fully first — wet mud smears rather than lifts, while dry mud can be brushed off before you even wet the laces, which saves a lot of scrubbing later. Once the loose mud is gone, follow the method above, but expect to do two soak-and-scrub cycles rather than one, since festival mud tends to sit deep in the weave. Odour is usually solved by the wash itself; if it lingers, a short extra soak in water with a splash of white vinegar (then a thorough rinse) deals with the bacteria causing the smell.
Cleaning reflective and waxed laces without damaging them
Reflective laces have a thin metallic coating bonded to the surface, and waxed laces have a wax finish that gives them their stiffness and water resistance. Both can be damaged by the scrub method above:
- Reflective laces: wipe rather than scrub. Use a damp cloth with a small amount of mild detergent and wipe along the lace in one direction. Avoid brushes entirely — bristles can lift or scratch the reflective layer, and once that's gone it doesn't come back.
- Waxed laces: spot-clean marks with a barely damp cloth and a tiny amount of detergent, then buff dry immediately with a separate dry cloth. Don't soak waxed laces — water breaks down the wax coating over repeated soaks, and they'll start absorbing dirt like ordinary cotton laces once that happens.
If a waxed lace has lost most of its wax finish and is now staining easily, cleaning won't restore the coating — at that point it's a case of judging whether the lace still looks acceptable or whether it's cheaper and quicker to just replace it.
Getting grey or yellowed laces properly white again
Laces that have gone an even grey or cream colour (rather than having a distinct stain) are usually suffering from ground-in fine dirt plus general ageing of the fibres, and a quick wipe won't shift that. A longer soak makes the real difference:
- Soak in warm water with a small amount of oxygen-based stain remover (the type sold for whites) for 30–60 minutes rather than the usual 15–20.
- Scrub as normal once the soak is done.
- For cotton laces only, a very dilute mix of water and a little household bleach (check the lace material first, and never use this on coloured or nylon laces) can bring back brightness on laces that are otherwise too far gone for detergent alone — rinse exceptionally thoroughly afterwards.
- Dry flat in indirect light. Direct sun can bleach unevenly and, over repeated washes, weaken the fibres.
Be realistic about this one: laces that are several years old and have gone thin as well as grey are showing general wear, not just dirt, and no amount of cleaning will make them look new. At that point, a cheap replacement pair often gives a better result than another wash cycle.
Common mistakes people make
- Leaving laces threaded through the shoe. Cleaning laces in situ means the eyelets and surrounding leather or mesh get soaked too, and the lace itself never gets scrubbed evenly.
- Using hot water on coloured laces. This is the single biggest cause of dye bleeding, especially on two-tone or patterned laces.
- Scrubbing reflective laces with a brush. Even a soft one will dull or damage the coating over time.
- Drying laces coiled up or hung over something. This sets a curl or kink that's genuinely difficult to undo once the lace is fully dry.
- Treating odour and staining as the same problem. A lace can look clean but still smell, or look stained but have no odour — they sometimes need slightly different treatment, as covered above.
When it's worth getting help instead of doing it yourself
Hand-cleaning laces at home deals with almost everything — everyday dirt, mud, light staining and general dullness. Where it's less straightforward is when the laces are part of a pair with wider problems: deep-set stains that have transferred from a damaged sole, suede eyelets that need matching care, or trainers where the laces are only one part of a bigger clean-up job. In those cases it often makes more sense to have the whole pair looked at together rather than treating the laces in isolation. FreshStep, a hand cleaning and restoration service based in Reading, takes pairs in for exactly that kind of full clean rather than just a spot treatment — useful if the laces are the least of your worries and the rest of the shoe needs attention too.
If you'd rather just sort the laces yourself and the trainers are otherwise fine, there's no need to overcomplicate it — the steps above will cover the vast majority of cases without any professional help at all.
FAQ
Can I put trainer laces in the washing machine on a delicate cycle?
You can, but it's a gamble. Laces can tangle around other items, lose their aglets, or come out twisted in a way that's hard to straighten once dry. Hand washing takes a little longer but gives a far more reliable result, especially for laces with a reflective or waxed finish.
How often should I clean my laces?
There's no fixed schedule — it depends on how often you wear the shoes and what you're walking through. As a rough guide, giving laces a proper wash whenever you clean the rest of the trainer, rather than waiting until they're visibly grey, keeps them from reaching the point where a longer soak is needed.
Will cleaning fix yellowed white laces completely?
Often, yes, if the yellowing is dirt-based. If it's genuine ageing of the fibres (common on laces that are a few years old), cleaning will improve them but may not get them back to original white.
Can I use bleach on all laces?
No — only on plain white cotton laces, and even then in a very dilute mix with thorough rinsing. Bleach will damage or discolour nylon, coloured, reflective and waxed laces, so check the material first.
Should I remove laces before washing the actual trainers?
Yes, always. Leaving laces in while washing the shoe means they don't get cleaned properly themselves, and wet laces threaded through eyelets can trap moisture against the upper longer than necessary.